In order to upload a RediGate configuration across a network, you need to know the RediGate's network address. Visit http://redigate.elecsyscorp.com/examples/ to See the Software page to download the latest default configurations which will have the have the default IP addresses for your particular RediGate model.
| Info | ||
|---|---|---|
| ||
If your RediGate 400 was made prior to 2017, the default configuration on the device may have different default IP addresses than the default configuration posted on the RediGate support site. Here is a list of the new and legacy default IP addresses for RediGate 400's: NEW (Post 2017 or later): Eth0 192.3.1.10 (subnet 255.255.255.0) Eth1 192.4.1.10 (subnet 255.255.255.0) Eth2 192.5.1.10 (subnet 255.255.255.0) Eth3 192.6.1.10 (subnet 255.255.255.0) OLD (Prior to 2017): Eth0 10.11.30.90 (subnet 255.255.0.0) Eth1 192.168.1.2 (subnet 255.255.255.0) Eth2 192.169.1.2 (subnet 255.255.255.0) Eth3 192.170.1.2 (subnet 255.255.255.0) If this is the first time you are uploading a configuration to your RediGate, you will need to set the IP address of your computer's Ethernet card to be on the same network as the RediGate's (see above). The screenshot below shows a network configuration for a laptop that is connected to Eth0 of a NEW default configuration:
|
...